ABK i-Cooking Instruction Manual page 14

3.4.6 Individual zone timer
The timer enables you to simultaneously
set an individual timing on each of the 3 or
4 zones [from 0 to 99 minutes]
Example: 16 minutes on power 7.
1. Switch on the appliance by pressing the
on/off symbol on the control panel.
2. Select the right zone by pressing the
symbol on the control panel ["0" and
indicator on display is lit].
3. Adjust the power to 7 by using the slider
or pressing it on the display.
4. Now you can activate the timer by
pressing on "CL". In the display you will
see "00". The number 16 now must be
entered in two steps [first "6" then "1"].
5. Move the slider until you see the
number "6". Confirm by pressing the timer
indicator.
7. Move the slider until you see the
number "1" and confirm again by pressing
the timer indicator."16".
To switch off the zone timer, repeat from
step 2 and set the time to "00".
If the zone timer reaches the set time, the
cooking zone will be switched off and "00"
b l i n k s i n t h e d i s p l a y, a n d a
beeping alarm sounds. By pressing on the
blinking "00" the alarm is switched off.
3.4.7 Timer
Additionally to the individual zone timer
you can also set a separate timer.
Follow the above steps, but WITHOUT
selecting a cooking zone [skip steps 2 and
3]
3.4.8 Automatic cooking
On each zone you can use the automatic
cooking function, which means it starts
cooking with maximum power and
automatically shifts back to the previously
set power if the required temperature is
reached.
Example: Automatic cooking, based on
power position 7.
1. Switch on the appliance by pressing the
on/off symbol on the control panel.
2. Select the right zone by pressing the
symbol on the control panel ["0" and
indicator on display is lit].
3. Adjust the power to 9 by using the slider
or pressing it on the display
4. Press the "9" again, so that now also the
"A" appears in the display.
5. Set the requested power position, from
"9" to "7". In the display both the "7" and
the "A" blink.
You can switch off the automatic cooking
function by first selecting the zone where
the "7" and the "A" blink. Then choose
another power position by using the slider
on the control panel.
EN 13 Use