Network Setup - Canon imagePRESS C700 Update Manual

As the Fiery Clone Tool restores the image file, the LED flashes "C1, C2, C3"
continuously to indicate the restore procedure is in progress.
When the restore process is complete, the LED flashes "CC", then "00" in one second
intervals, and repeats to indicate completion status.
1. Remove the USB flash drive.
2. Reboot the G100 Fiery server from the power switch of the controller.

Network Setup

Power-up and verify that the imagePRESS Server G100 connects to the engine then
proceed with setup. Once enabled and the imagePRESS Server G100 is detected by
the engine, the Fiery icon will appear on the Main Menu of the Canon User Interface. It
may take up to 7 minutes for the imagePRESS Server G100 to boot and be
detected by the engine.
The network settings will be configured in this step. Using the Canon UI and Fiery
Button follow the steps below to access the network configuration. The remaining
configuration settings of the imagePRESS Server G100 will be configured using
Command Workstation in section [4] after adding the device to Command Workstation.
1. Press the Fiery Button as shown above
2. Press the Cog at the bottom of the screen  Zoom  75%  OK (This will
ensure you can see the entire screen)
3. Press Tools  Setup  enter password [Fiery.1]  [Login]
4. Press Network  IPv4  uncheck [Get IP address automatically]  Enter [IP
address], [Subnet Mask] [xxx.xxx.xxx.xxx] is the correct subnet and [Gateway]
addresses.
5. Uncheck [Get DNS address automatically] then enter [Primary DNS]
[170.170.137.252] and [Secondary DNS]  [170.170.137.253]
6. Uncheck [Use WINS]
7. Scroll up, select [Save Changes]
8. Press [Exit Setup]  [Reboot Now]
9. The controller will come to an idle state within 7 minutes. Once idle, proceed to
the next section.
16 imagePRESS C700 & imagePRESS Server G100 January 2017 Update Guide