Canon imagePRESS C700 Update Manual page 15

Restoring the FXO Clone image
To restore the clone image
1. On a Windows computer, verify that the USB flash drive has the correct cloned
image file for the G100 FXO Fiery server. (see instructions for creating the Clone
image)
a. Insert the USB flash drive into a USB port on the Windows computer
b. In Windows Explorer, open the USB flash drive to check the files. (see
instructions for creating the Clone image)
2. Shut down the C700 and ensure that the C700 and G100 are powered off. (wait until
the LED's are off on the G100 before continuing).
3. Attach the USB flash Drive to an available USB port on the G100 Fiery Server
4. Set service switch 1 up (ON), and service Switch 2 down (OFF)
Service switch binary configuration [1, 0].
5. Power on the C700
6. Allow the Fiery G100 server to boot from the USB flash drive to start the Fiery Clone
tool.
7. Wait until the Fiery G100 server LED flashes "AA" then "00" repeatedly to indicate
ready status
8. Set both service switches down (OFF)
Service switch binary configuration [0, 0].
The LED displays "C0" to indicate that the Fiery G100 server is ready to be restored.
January 17, 2017