Printing - Printa Systems 990 series Quick Manual

Step 1: Place packing tape
over product so you can
safely print without marking
on it.
Step 4: Pull bed slide to left:
cleaning off plate with
doctor blade.
Step 7. After plate is cleaned
properly, wait several sec-
onds before coming down
onto plate. This will help the
thinner evaporate and ink
adhere to the pad.
990 Pad Printing System Quick Guide
Step 2: Slide bed-slide to
right, flooding plate.
Step 5: Plate should be
cleaned off evenly like
above.
Step 8: Lift pad and slide
bed-slide back to right. Hold
pad in air for several seconds
to let ink become tacky so it
will release fully from the
pad onto the product.

Printing

Step 3: Plate should be
completely covered.
Step 6: If plate is not cleaned
evenly, then adjust angle of
ink carriage using angle
adjustment knob.
Step 9: Lower pad onto
product to release ink. Hold
for a second on the product.
The entire print cycle should
be around ten seconds.
9