Final Set Up Of 990 System - Printa Systems 990 series Quick Manual

990 Pad Printing System Quick Guide
Step 1: Install pad onto pad
mount. Leave pad loose in
mount so you can adjust pad
according to the artwork.
Step 4: Tighten down plate
keepers bolts.
Step 7: Pour all if ink into ink
tray. Note the cam lever bar
is in the 2 o'clock position.
Test ink by running mixing
stick through it. The ink
should close up in 3 seconds.
If it takes longer, then add
8
thinner to mixture.
Step 2: Install ink tray. Slide
under plate keeper on far
left of ink tray.
Step 5: Install ink carriage
assembly.
Step 8: Lower pad to plate.
Check pad position in
reference to artwork. Move
pad until centered on art-
work, then tighten pad onto
pad mount.
Step 3: Place plate on top of
tray liner. Slide under plate
keeper bar: plate may extend
from end of bar but this will
not cause any problems.
Step 6: Secure ink carriage
by locking down Nylon nut.
Remember not to over-
tighten!
Step 9: Slide bed slide to
right. Lower pad to product:
make sure that it is in the
general print area of the pad.