Printing................................................................................................... - Printa Systems 990 series Quick Manual

Step 10: Look at print on
product to see if it is aligned
properly.
Step 13: Place packing tape
on product and repeat steps
1 - 12 until you are satisfied
with the print.
* Print Cycle should be about 10 seconds on average.
* Always use 25 - 30 grams of ink, the correct thinner and hardener.
* If printing on plastic, always test by placing small dab of thinner on product: if it melts or becomes dull,
then continue with the printing process. If it wipes off, then you will need to either pretreat the product
before printing or use a special type of ink designed for plastics.
* SE hardener is for woods and plastics, VR is for glass and metals. DO NOT mix either thinner or hardener as
it will cause the ink to gel.
10
990 Pad Printing System Quick Guide
Step 11: If it is not, loosen
the turntable lock stud so
the table rotates freely.
Step 14: Once you have aligned
print and are ready, remove tape
and begin print run. Remove
product after print while the plate
is flooded.
Printing
Pad Printing Tips
Step 12: Use the X & Y Axis
adjusters to move the turn-
table assembly. When done,
secure turntable lock stud.
Step 15. The finished product!