Initial Set Up: Ink Carriage Assembly - Printa Systems 990 series Quick Manual

990 Pad Printing System Quick Guide
Step 1: Familiarize yourself with
the ink carriage assembly. Take a
moment or two to install and
uninstall the ink roller.
Step 3: Ink carriage assembly
should look like this.
Step 5: Practice a couple times
putting the ink carriage into inner
and outer posts. Do this until you get
comfortable. Make a note that the
post that has the angle adjustment
knob (black knob) has a spring inside
of it.
4
Ink Carriage Assembly
Step 2: Install doctor blade into the blade
keeper. Make note that grounded edge of
doctor blade is out and down. Press blade
against plate keeper screws and tighten.
Step 4: Hold ink carriage assembly as
follows.
Step 6: Once ink carriage is installed,
tighten down with nylon nut. Once firm,
turn back 1/16th of an inch. You do not
want the nut to be completely tightened
or the ink carriage will not work properly.