Cisco MDS 9216 Configuration Manual page 63

Chapter 7 Configuring Copy Services
Number of mdisks is 1
Number of vdisks using this group is 0
Tip
Enter the cluster configuration submode for the cluster called SampleCluster.
Step 5
switch(svc)# cluster config SampleCluster
switch(svc-cluster)#
Issue the migration command to the new MDisk group.
Step 6
switch(svc-cluster)# migrate vdisk fn-data new-mdisk-grp finance2
switch(svc-cluster)# migrate vdisk fn-log new-mdisk-grp finance2
switch(svc-cluster)#
Exit to the svc-config submode
Step 7
switch(svc-cluster)# exit
switch(svc)#
Check the progress of the migration by issuing the status command.
Step 8
switch(svc)# show cluster SampleCluster status migration
switch(svc)#
Verify that the migration has completed, by using the show VDisk command. The
Step 9
column should have the new MDisk group name.
switch(svc)# show cluster SampleCluster vdisk
-------------------------------------------------------------------------------
Name
-------------------------------------------------------------------------------
fn-data
fn-log
switch(svc)#
78-16119-01, Cisco MDS SAN-OS Release 1.3
In order to migrate a VDisk from its existing MDisk group to a new one MDisk group, both the
MDisk groups must have the same extent size.
migrating vdisk fn-data to mdisk grp finance2 : 68%
migrating vdisk fn-log to mdisk grp finance2 : 0%
Capacity
1.00 GB
1.00 GB
iogroup mdisk-grp name
1 finance2
1 finance2
Cisco MDS 9000 Family SAN Volume Controller Configuration Guide
Data Migration
mdisk-grp name
Policy Status
striped online
striped online
7-3