Download Print this page

Specification - Sealey PWM2500SP Instructions Manual

220bar 600ltr/hr self priming 6.5hp petrol

Advertisement

DO NOT start the engine if there are any flammable materials near the exhaust system or in the path of the exhaust gases.
8
DO NOT block the engine ventilation grilles.
8
Ensure engine fuel is stored in an approved container.
9
For long term storage ensure the fuel is drained and that the washer is adequately protected against frost.
9
DO NOT operate the engine with either the silencer or air filter removed.
8
DO NOT touch the engine during or after use. To avoid burns allow it to cool before handling.
8
‰ ‰ ‰‰ WARNING! The warnings referred to in this guide cannot cover all possible conditions and situations that may occur. It must be
understood that common sense and caution are factors which cannot be built into this product, but must be applied by the operator.
NOTE: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack
of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
2. INTRODUCTION
Petrol powered pressure washer with recoil starting. Ideal for commercial applications: with 5mtr pressure hose, 1mtr gun and lance and adjustable
nozzle. Self priming pump makes this unit fully portable and can be used where no mains pressure is available. Can draw clean water from water
butts and tanks etc. Low-pressure liquid detergent injection system with provision for detergent bottle stowage. Safety latch on trigger and automatic
low-oil engine shutdown reduce risks of misuse and equipment damage. Unit stands on four legs, two with sucker feet to prevent creep, and tilts back
onto two pneumatic tyred wheels for moving. Supplied with tools and full Instructions.

3. SPECIFICATION

MODEL NO: ........................................................ PWM2500SP
Manifold Pressure: ...........................................175bar/2538psi
Maximum Pressure: .........................................220bar/3190psi
Flow Rate: ................................................................... 600ltr/hr
Hose Length: ..................................................................... 5mtr
Nozzle: ................................... 0°, 15°, 25°, 40° fan & detegent
Maximum Inlet Temperature: .............................................50°C
Engine Type:...........................4 Stroke, Single Cylinder, Petrol
Engine Capacity: ............................................................. 196cc
Engine Power ..................................................................6.5hp
Starting: ...........................................................................Recoil
Fuel Tank: .............................................................................4ltr
Fuel Consumption: ............................................... 2.1 - 2.6ltr/hr
Weight: ..............................................................................42kg
Noise Level: ............................................................... 109dB(A)
Pump Oil ................................................................SAE15W-40
Engine Oil ..............................................................SAE10W-30
fig.1
© Jack Sealey Limited
Original Language Version
PWM2500SP | Issue:3 13/07/17

Advertisement

loading