Table of Contents
Advertisement
DO NOT check ignition system by removing the spark plug or spark plug lead. Use specific tester or contact service agent.
8
DO NOT operate the washer in an enclosed area as the motor exhaust fumes are a health hazard. Always ensure adequate ventilation.
8
DO NOT use the washer with flammable, toxic or corrosive liquids.
8
DO NOT leave the washer unattended whilst operating, and DO NOT remove the fuel cap whilst the engine is running.
8
DO NOT refuel the engine whilst it is running. Stop the engine and allow it to cool for two minutes before attempting to refuel.
8
DO NOT refuel in a closed or poorly ventilated environment as there is a danger of explosion or fire. Refuel out doors.
8
DO NOT smoke or place the washer near any naked flames whilst re-fuelling.
8
DO NOT operate washer if there is a fuel leak. Move the unit and avoid using until the leak has been fixed and the machine is dry.
8
DO NOT start the engine if there are any flammable materials near the exhaust system or in the path of the exhaust gases.
8
DO NOT block the engine ventilation grilles.
8
Ensure engine fuel is stored in an approved container.
9
For long term storage ensure the fuel is drained and that the washer is adequately protected against frost.
9
DO NOT operate the engine with either the silencer or air filter removed.
8
DO NOT touch the engine during or after use. To avoid burns, allow it to cool before handling.
8
2. INTRODUCTION
Petrol powered pressure washer with recoil starting. Suitable for commercial and domestic applications with 5m pressure hose, gun, lance and
adjustable nozzle. Low-pressure liquid detergent injection system. Safety latch on trigger. Unit stands on two sucker feet to prevent movement and
two wheels for easier mobility with an integral handle. Supplied with tools and full instructions.
3. SPECIFICATION
Model no: ......................................................... PWM1300.V2
Manifold pressure: ...................................... 110bar (1595psi)
Maximum pressure:...................................... 150bar(2175psi)
Flow rate: .................................................................... 6L/min
Hose length: ...................................................................... 5m
Nozzle: ....................................................... adjustable nozzle
Maximum inlet temperature: ........................................... 40°C
Engine type: ............................4 stroke, single cylinder petrol
Engine capacity: ........................................................... 141cc
Engine power: .................................................................. 4hp
Starting: ........................................................................ recoil
Fuel tank: ........................................................................... 1L
Fuel consumption: ....................................................0.8-1L/hr
Noise level: ............................................................. 103dB(A)
4. ASSEMBLY AND PREPARATION
Unpack contents and check to ensure all parts are in good condition.
fig.1
fig.1
© Jack Sealey Limited
Oil capacity ................................................................... 0.55L
Oil spec. ..............................................................SAE10W-30
Max inlet water pressure ............................................0.4MPa
Min inlet water pressure .............................................0.2MPa
Item No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Original Language Version
Description
Starter cord
Spark plug
Temperature relief valve
Spray gun
Fuel tank cap
Choke control
Engine On/Off switch
Air filter
Pump outlet
Accessory store
Pressure hose
Oil dipstick
Exhaust
Pump inlet
Fuel tank
Detergent connection
PWM1300.V2 Issue 2 (2) 07/12/20
fig.2
Advertisement
Table of Contents
