Troubleshooting - Radio Shack PRO-82 Owner's Manual

6417$.'5*116+0)
2TQDNGO
Scanner is totally
inoperative.
Poor or no
reception.
The keypad does
not work.
The scanner is on
but will not scan.
During scanning,
the scanner locks
on frequencies
that have an
unclear
transmission.
2QUUKDNG"%CWUG
The AC or DC
adapter is not
connected.
The batteries are
dead.
An antenna is not
connected or is
connected
incorrectly.
Programmed
frequencies are the
same as "birdie"
frequencies.
Keylock is turned
on.
The scanner might
need to be reset or
initialized.
SQUELCH is not
correctly adjusted.
Only one channel or
no channels are
stored.
Programmed
frequencies are the
same as "birdie"
frequencies.
4GOGF[
Be sure the
adapter's barrel plug
is fully inserted into
the PWR jack.
Replace non-
rechargeable
batteries with fresh
ones, or recharge
the rechargeable
batteries.
Be sure an antenna
is properly
connected to the
scanner.
Avoid programming
frequencies listed
under "Birdie
Frequencies" on
Page 41 or only
listen to them
manually.
Turn off keylock.
Turn the scanner off
then on again, or
reset/initialize the
scanner (see
"Resetting/Initializing
the Scanner" on
Page 38).
Turn SQUELCH
clockwise.
Store frequencies
into more than one
channel.
Avoid programming
frequencies listed
under "Birdie
Frequencies" on
Page 41, or only
listen to them
manually.
51