Let's Get Brewing; Cleansing Brew; Set-Up - Keurig K200 PLUS Series Use & Care Manual

SETUP
1. Place the brewer on a counter and plug
into a grounded outlet.
3. Remove the Water Reservoir and rinse.
While removed, fill with bottled or
filtered water, and return to the brewer.
Be sure to fill below the MAX FILL line
and above the MIN FILL line.
NOTE: The reservoir only needs to be removed and filled for
the initial set up. After the first fill, you can refill the Water
Reservoir either while it is attached to the brewer or removed.
2. Lift the Handle, remove and discard the
shipping disk.
4. Press the Power Button and wait
for preheating to complete, about
three minutes.
10

CLEANSING BREW

1. To begin a cleansing brew, place a
12 ounce mug on the Drip Tray.
3. Press CONTINUE to dispense hot water.
Select a 8 ounce Brew Size and press the
Brew Button.

1 | LET'S GET BREWING!

2. Lift and lower the Handle. Do not place a
Keurig brand pod in the Pod Holder.
®
4. You are now ready to use your brewer!
11