Keurig K200 PLUS Series Use & Care Manual page 14

CARING FOR YOUR BREWER
DESCALING YOUR BREWER (CONTINUED)
The cleaning action of Keurig Descaling Solution may result in a foam dispensed from the
™
brewer. This is natural, as the solution is reacting with the scale inside. For a brewer that is
heavily scaled, the brewer may not fill properly after the descaler is added. If this occurs, you
may see only a small or no output dispensed followed by the sound of air blowing out.
If this occurs:
• Turn off and unplug the brewer.
• If there is Keurig Descaling Solution in the Water Reservoir, discard the contents,
™
rinse the Water Reservoir thoroughly and refill with bottled or filtered water.
• Plug the brewer back in, power on, and repeat STEP 3: FRESH WATER RINSE (refer to
page 10). The brewer should begin to function normally as the solution is rinsed out and the
scale is removed. If the problem persists, allow the brewer to sit unplugged for at least 30
minutes then continue with the fresh water rinse.
26
RECYCLING K-MUG™ AND K-CARAFE™ PODS
The plastic cups of K-Carafe pods can be
™
recycled wherever #5 plastic is accepted.
#5 plastic may not be recyclable in your
community today, so please check locally
with your municipality or waste hauler.
2. Once cool, separate the lid and filter
from the cup. The filter will adhere to
the lid.
2 | TIPS & MAINTENANCE
1. Once brewing is complete, lift the
Handle and carefully remove the
K-Carafe pod by holding the
™
outer rim.
CAUTION: The K-Carafe pod will be hot after brewing.
™
Use caution when removing. Allow it to cool completely
before handling.
3. Once separated, discard the lid and the
attached filter. Recycle your K-Carafe™
pod's plastic cup wherever #5 plastic
is accepted.
27