Table of Contents
Advertisement
This command is available for all network devices with two exceptions:
The command cannot be performed on the System Manager
The Reset to factory defaults option is not available on the gateway
Read Object Attribute
Using this command you can read attributes from an object on the selected device.
To read an attribute, type in the UAP specific TSAP ID (port), the Object ID, and the Attribute
ID you wish to read. Then click Execute.
The values of the two indices are 0 by default and the value of the Committed Burst field is
NOTE:
-15 by default.
The command returns the content of the attribute, which will be displayed in hex format in the
Response column of the Commands Log page.
November 2017
Page 55
Advertisement
Table of Contents
