Table of Contents
Advertisement
The following types of commands are available:
Read Value
This command is available only for field devices and enables you to read a value on a particular
channel of the selected device.
To generate the command, select the process value for which to request a reading and click
Execute. The returned value will be displayed in the Readings page, in engineering units under
the Value column as well as in the Command Log, under the Response column.
NOTE:
When the device is unregistered, the Run Commands tab is unavailable.
Reset Device
This command resets the firmware on the specific device.
Three types of resets can be performed on a device:
Warm Restart – performs a software reset; as a consequence, the device will unregister
and re-register
Restart as provisioned – resets the device while keeping provisioning information
Reset to factory defaults – deletes the provisioning information and resets the device to
its manufacturing settings; the device must be re-provisioned in order to be able to join
the network
November 2017
Page 54
Advertisement
Table of Contents
