Unipower ARE-M02406 Product Manual page 3

Micro ARE-M Series 24V Chargers, Single Phase
EQUIPMENT INSPECTION
Promptly upon receipt of shipment, open the container and inspect the contents for damage; see the
unpacking section that follows. If it is necessary to move or otherwise handle the shipment, refer to the
Handling section for instructions and warnings.
Unpack the shipment carefully to avoid scratching or otherwise marring the exterior finish. Be careful not
to discard any included equipment, parts, or manuals. If damage is detected, call the delivering carrier to
determine appropriate action. The carrier may require an inspection.
IMPORTANT: If damage is detected, save all shipping material for the carrier's representative!
If damage is detected, also notify UNIPOWER, LLC; contact information is in Section 1.5 Product
Support UNIPOWER, LLC will determine if the equipment should be returned for repair. If it is
determined that the equipment should be returned to UNIPOWER, LLC, ask the delivering carrier to send
the packages back to UNIPOWER, LLC at the delivering carrier's expense. Be sure that the equipment is
properly packaged for shipment.
If repair is necessary, UNIPOWER, LLC will invoice you for the repair so that you may submit the bill to
the delivering carrier with your claim form.
It is your responsibility to file a claim with the delivering carrier. Failure to properly file a claim for
shipping damages may void warranty service for any physical damages later reported for repair.
UNPACKING
A charger is shipped attached to a wood skid. This facilitates handling with a lift truck by inserting the
forks under the bottom of the skid. A smaller unit is covered by a carton and banded to a skid. A larger
unit is bolted to a skid and covered by a shipping carton that is banded to the skid.
Export packaging consists of a crate, a moisture-resistant cover for the charger, and a drying agent. The
charger is bolted to the crate.
To unpack:
CAUTION
Do not stand in front of steel bands since they may
whip out when cut.
Cut the bands and remove carton from the skid.
1. Either remove the unit from the carton or unbolt the unit from the skid.
2. Check the shipping carton, before discarding, for the packing slip and other material, which may
be contained in it.
3. Carefully inspect the charger for shipping damage (i.e. loosened connections or mountings,
dislodged circuit boards). If damage is detected, notify UNIPOWER, LLC; contact information
is provided in Section 1.5 Product Support.
STORAGE
If the charger is not to be used immediately, store it (fully packed, if possible) in a clean, dry location
protected from physical damage, condensation, and overhead drip.
ATTENTION
Ne pas se tenir devant les bandes d'acier, lorsque
coupées.
ii
Front Matter
PM990-1070-24, Issue 12