Basic safety instructions
1.1.4
Symbols for certain types of information
in preparation
1.1.5
Symbols in graphics
in preparation
2
Basic safety instructions
2.1
Requirements concerning the staff
The staff must fulfill the following requirements for their tasks:
Trained staff: Must have a qualification which corresponds to their function and tasks.
►
Authorized by the plant operator.
►
Familiar with the national regulations.
►
Before starting their work: Must have read and understood all instructions in the operating
►
manual and supplementary documentation as well as the certificate (depending on the
application).
Must comply with all instructions and the regulatory framework.
►
2.2
Designated use
Application and measured materials
The measuring device described in these Operating Instructions is intended only for level and
interface measurement of liquids. Depending on the version ordered the device can also
measure potentially explosive, flammable, poisonous and oxidizing materials.
Observing the limit values specified in the "Technical data" and listed in the Operating
Instructions and supplementary documentation, the measuring device may be used for the
following measurements only:
Measured process variable: Level and/or interface
►
Calculated process variable: Volume oder mass in arbitrarily shaped vessels (calculated
►
from the level by the linearization functionality)
To ensure that the measuring device remains in proper condition for the operation time:
Use the measuring device only for measured materials against which the process-wetted
►
materials are adequately resistant.
Observe the limit values in "Technical data".
►
Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Verification for borderline cases:
For special measured materials and cleaning agents, Endress+Hauser is glad to provide
►
assistance in verifying the corrosion resistance of wetted materials, but does not accept any
warranty or liability.
4
Levelflex FMP55
Endress+Hauser
Need help?
Do you have a question about the Levelflex FMP55 and is the answer not in the manual?