Post-Connection Check; Integration Into A Foundation Fieldbus Network; Device Description (Dd); Integration Into The Foundation Fieldbus Network - Endress+Hauser Levelflex FMP55 Operating Instructions Manual

Levelflex FMP55
7.5

Post-connection check

Are cables or the device undamaged (visual inspection)?
Do the cables comply with the requirements?
Do the cables have adequate strain relief?
Are all cable glands installed, firmly tightened and correctly sealed?
Does the supply voltage match the specifications on the transmitter nameplate?
Is the terminal assignment correct (® ä 18)?
If required: Is the protective earth connected correctly (® ä 18)?
If supply voltage is present: Is the device ready for operation and do values appear on the display
module?
Are all housing covers installed and firmly tightened?
Is the securing clamp tightened correctly?
8

Integration into a FOUNDATION Fieldbus network

8.1

Device Description (DD)

You require the following to configure a device and integrate it into an FF network:
• An FF configuration program
• The Cff file (Common File Format: *.cff)
• The device description (DD) in one of the following formats
– Device Description format 4 : *sym, *ffo
– Device Description format 5 : *sy5, *ff5
Information on the device-specific DD
Manufacturer ID
Device Type
Device Revision
DD Revision
CFF Revision
8.2

Integration into the FOUNDATION Fieldbus network

• For more in-depth information on integrating the device into the FF system, see the
description for the configuration software used.
• When integrating the field devices into the FF system, make sure you are using the
right files. You can read out the required version by means of the Device Revision/
DEV_REV and DD Revision/ DD_REV parameters in the Resource Block.
Endress+Hauser
452B48hex
100Fhex
05hex
Information and files at:
• www.endress.com
• www.fieldbus.org
Integration into a FOUNDATION Fieldbus network
25