Hop Count; Boundary Ports - Cisco Nexus 3000 Series Configuration Manual

Hop Count

• The CIST external root path cost is the cost to the CIST root. This cost is left unchanged within an MST
• If the CIST root is in the region, the CIST regional root is the CIST root. Otherwise, the CIST regional
• The CIST internal root path cost is the cost to the CIST regional root in a region. This cost is only relevant
Hop Count
MST does not use the message-age and maximum-age information in the configuration BPDU to compute
the STP topology inside the MST region. Instead, the protocol uses the path cost to the root and a hop-count
mechanism similar to the IP time-to-live (TTL) mechanism.
By using the spanning-tree mst max-hops global configuration command, you can configure the maximum
hops inside the region and apply it to the IST and all MST instances in that region.
The hop count achieves the same result as the message-age information (triggers a reconfiguration). The root
bridge of the instance always sends a BPDU (or M-record) with a cost of 0 and the hop count set to the
maximum value. When a switch receives this BPDU, it decrements the received remaining hop count by one
and propagates this value as the remaining hop count in the BPDUs that it generates. When the count reaches
zero, the switch discards the BPDU and ages the information held for the port.
The message-age and maximum-age information in the 802.1w portion of the BPDU remain the same throughout
the region (only on the IST), and the same values are propagated by the region-designated ports at the boundary.
You configure a maximum aging time as the number of seconds that a switch waits without receiving spanning
tree configuration messages before attempting a reconfiguration.

Boundary Ports

A boundary port is a port that connects one region to another. A designated port knows that it is on the boundary
if it detects an STP bridge or receives an agreement proposal from an MST bridge with a different configuration
or a Rapid PVST+ bridge. This definition allows two ports that are internal to a region to share a segment
Cisco Nexus 3000 Series NX-OS Layer 2 Switching Configuration Guide, Release 6.x
84
region. An MST region looks like a single switch to the CIST. The CIST external root path cost is the
root path cost calculated between these virtual switches and switches that do not belong to any region.
root is the closest switch to the CIST root in the region. The CIST regional root acts as a root bridge for
the IST.
to the IST, instance 0.
Configuring Multiple Spanning Tree
OL-29545-03