Troubleshooting; Recycling And Disposal - Mantis 3550 Original Operating Instructions

Troubleshooting

Suspected malfunctions are often due to causes that users can fix themselves. Therefore check malfunctions using this section. In most cases
the problem can be solved quickly.
Only perform the steps described within these instructions! All further inspection, maintenance and repair work must be performed
by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself! For assistance contact the
Problem
1. Tiller/cultivator does not start
2. Tiller/cultivator does not reach
full power
3. Unsatisfactory result
4. Excessive vibration or noise

RECYCLING AND DISPOSAL

The product comes in a package that protects it against damage during shipping. Keep the package until you are
sure that all parts have been delivered and the product functions properly. Recycle the package afterwards.
WEEE symbol. Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or local store for recycling advice.
Electric Tiller/Cultivator Troubleshooting
Mantis customer service center at 1-800-366-6268.
Cause
1.1. Not connected to power supply
1.2. Power cord or plug is defective
1.3. Other electrical defect to the product
2.1. Extension cord not suitable for
operation with this product
2.2. Power source (e.g. generator) has
too low voltage
2.3. Air vents are blocked
3.1. Tines are dull/damaged
3.2. Tines not suitable for ground material
4.1. Tines are dull/damaged
4.2. Bolts/nuts are loose
WEEE symbol. Waste electrical products should not be
disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or local store
for recycling advice.
Contact us at www.mantis.com
Remedy
1.1. Connect to power supply
1.2. Check by a specialist electrician
1.3. Check by a specialist electrician
2.1. Use a proper extension cord
2.2. Connect to another power
source
2.3. Clean the air vents
3.1. Replace with new tines
3.2. Use product only on suitable
ground
4.1. Replace with new tines
4.2. Tighten bolts/nuts
15