Equinox Systems EQ-TD-4286 Owner's Manual page 14

At the time of your alarm, the meter will beep and automatically turn
on. You can press M to silence the alarm and insert a test strip to begin
testing. If you do not press M, the meter will beep for 2 minutes then
switch off. If you do not want to test at this time, press M to switch off the
meter.
Congratulations! You have completed all settings!
NOTE:
• These parameters can ONLY be changed in the setting mode.
• If the meter is idle for 3 minutes during the setting mode, it will switch off
automatically.
Press M to select "On", then press SET to
set the hour. When the hour is flashing,
press M to add an hour. Press SET to
confirm and go to minutes, press
M to add one minute. Hold M longer to
add faster. Press SET to confirm and go to
the next alarm setting.
If you do not want to set an alarm, press
SET to skip this step.
If you want to turn off an alarm, find the
alarm number by pressing SET in the
setting mode, press M to change from
"On' to "OFF".
13