Gpib Configuration; Configuring The Ni-488.2 Software Characteristics; Configuring The Software - National Instruments GPIB-ENET/100 Getting Started

GPIB Configuration

Configuring the NI-488.2 Software Characteristics

Configuring the Software

© National Instruments Corporation
This chapter describes how to configure your HP-UX workstation to use
the GPIB-ENET/100.
The default settings for NI-488.2 work for most applications and devices.
However, you might want to change a device name or primary address.
Also, if more than one GPIB interface is installed, you might want to
associate a device with a particular interface.
The GPIB software configuration utility,
that you can use to examine or modify the driver configuration.
To run , enter the full path to the GPIB software configuration
ibconf
utility. The default path is as follows:
<Install Directory>/ibconf
displays a list of all the GPIB interfaces and device names, as
ibconf
shown in Figure 4-1. Context-sensitive online help is available to describe
each configuration option.
ibconf
4-1
4
, is an interactive utility
GPIB-ENET/100 for HP-UX