Initial Setting - Mitsubishi Electric PAR-W21MAA Instruction Book

7

Initial Setting

E
1. Water temperature initial setting
Water Temp Heating
1 Water temperature display
8. Water temperature initial setting
Temp Offset Cooling
0 Offset amount display
*The available settings differ depending on the model of the unit to connect.
F
I
J
K
D
2. Water temperature initial setting
Water Temp Heating ECO No.1
2 Water 3 Outside air
temperature temperature display
(
display
Outside air temperature
setting of Heating ECO
No.2 must be higher
than that of Heating
ECO No.1.
7. Water temperature initial setting
Temp Offset Heating
9 Offset amount display
The initial operation mode can be set. Change the setting when needed.
(1) Water temperature initial setting mode
1 Stop the unit by pressing the [
2 To enter the water temperature initial setting, press and hold down the
[INITIAL SETTING ( )] J button for three seconds or longer. (Any of
1. to 8. will be displayed.)
* Wait a while because the water temperature initial setting takes
approximately 30 seconds to display after the [INITIAL SETTING (
J button is pressed.
* Depending on the model of the unit to connect, the water temperature
initial setting may not be possible. In such case, the screen transitions
to the unit stop screen after the display of the error.
3 To select a water temperature initial setting from 1. to 8., press the
[Mode (Return)] E button.
3. Water temperature initial setting
Water Temp Heating ECO No.2
4 Water 5 Outside air
temperature temperature display
) (
display
Outside air temperature
setting of Heating ECO
No.2 must be higher
than that of Heating
ECO No.1.
6. Water temperature initial setting
Water Temp Cooling
8 Water temperature display
– 22 –
ON/OFF] I button.
4. Water temperature initial setting
Water Temp Hot Water
6 Water temperature display
)
5. Water temperature initial setting
Water Temp Anti-freeze
7 Water temperature display
)]