Your new entries at Steps 2 and 3 will be cancelled if you press the Mode (Return)
button 2 before pressing the CIR.WATER
5. Press the Mode (Return) button 2 to complete the setting procedure. This will
return the display to the standard control screen, where 1 will now show the newly
set day and time.
Using the Remote Controller
(1) How to Start, Stop, Change the Mode, and Adjust the Water
<To Start Operation>
Press the ON/OFF button 1.
• The ON lamp 1 and the display area
When the unit is restarted, initial settings
are as follows.
Remote Controller settings
Last operation mode
Last set temperature
– 7 –
<To Stop Operation>
Press the ON/OFF button 1
• The ON lamp 1 and the
display area go dark.