Mounting - GE MultiNet Instruction Manual

INSTRUCTION MANUAL
6.

Mounting

6
MultiNet is DIN rail mountable and ships with two DIN rail clips attached on the rear of the
unit. The DIN rail clips can attach the unit onto a standard 35 mm DIN rail. Place the top
hooks of the clip against the DIN rail and apply a downward force until an audible click is
heard. In order to remove the unit, place a standard slotted screwdriver between the unit
and the DIN rail and apply an upward force.
Each clip is held onto the unit using a standard 4-40 Phillips head screw. If the DIN rail
option is not used, remove the DIN rail clips by unscrewing the six screws. Once the clips
have been removed re-screw the six screws back into their original positions. Do not
substitute screws, since the wrong length of screw may damage the internals of the
product and void the warranty.
FIGURE –2: Typical Configurations
MULTINET SERIAL TO ETHERNET CONVERTER – INSTRUCTION MANUAL