Accessories Available
For accessories not listed in this section, refer to the configuration guide for your analyzer
or refer to the following Internet site:
www.agilent.com/find/8753
Measurement Accessories
Accessories are available in these connector types: 3.5-mm, 7-mm, 50 Ω type-N, 7-16, 75 Ω
type-N, and type-F. A standard 8753ES or one equipped with Option 014 or Option 075
includes a built-in test set. A calibration kit and test port cables should be added for a
complete measurement system. For an 8753ES Option 011 network analyzer, you also
need to add a test set or power splitter and bridge.
Test port cables are used to connect to the device under test. Calibration kits include
standards, such as open/short circuits and loads, which are measured by the network
analyzer for increased measurement accuracy. Electronic calibration (ECal) modules are
used with the ECal PC interface kit to provide automated calibration (in place of a
calibration kit). A verification kit is used to verify system performance.
Test-Port Cables: 7-mm
• 11857D 50 Ω 7-mm test-port return cables
A pair of 610-mm (24-in) cables, for use with the standard 8753ES network analyzer or
the 85406A and 85047A test sets.
Test-Port Cables: Type-N
• 11857B 75 Ω type-N test-port cables
A pair of 610-mm (24-in) cables, for use with the standard 8753ES Option 075 or the
85046B S-parameter test set.
• 11857F 75 Ω type-N test-port cables
Includes one 75 Ω type-N (m) to type-F (m) cable, and one type-N (m) to type-F (f).
Calibration Kits
Choose a kit for each connector type to be used.
• 85031B 7-mm calibration kit
Contains fixed loads, open and short circuits.
• 85032B type-N calibration kit
Contains fixed loads, open and short circuits and 7-mm to type-N adapters.
— Option 001
Deletes 7-mm to type-N adapters.
These adapters are not needed when this kit is used exclusively with an 8753ET
system.
Options and Accessories
Accessories Available
7-5