Calibrate Or Reset; Set Preferred Heights; Set Maximum Load Capacity; Measurement Conversion - StandDesk PRO Assembly Manual

WAKE UP:
Press any button!

CALIBRATE OR RESET:

Press and hold
Hold until display shows
Stands for go to lowest position to tell you that your desk must be re-set. See above.
GLP:
Stands for connection if one of the frame legs is not working properly. Unplug the device and plug it
CON:
back in.
Stands for hit. This protects your desk against collisions that could lead to damage. If something hits
HIT:
your frame while it is raising or lowering, it will automatically stop and memory handset will read
Stands for overheat if the desk has had two minutes of constant usage. To resolve, wait 15 minutes for
OH:
your desk to cool down.
Stands for overload or too much weight on your frame. Either remove some weight or change the load
OLU:
capacity on your frame in settings (see max/min load capacity).

SET PREFERRED HEIGHTS:

To save your first preferred height; elevate your desk to your desired height with the up/down buttons.
Press then press
SET MAXIMUM HEIGHT:
Press and hold
reaches your hightest desired height (max is 49"), release. Then press
SET MINIMUM HEIGHT:
Press and hold
reaches your lowest desired height, release. Then press
SET MAX/MIN LOAD CAPACITY:
Press and hold
Press then adjust maximum and minimum load capacity by using
Press to exit or press

MEASUREMENT CONVERSION:

Press and hold
Press then switch between inches (1) and centimeters (0) by using
Press to exit or press
COLLISION SENSITIVITY:
Press and hold
Press then adjust sensitivity (5-30) by using
Press to exit or press
MEMORY HANDSET MANUAL
for 15 seconds. Led display shows
. Release; the display shows 24".
to save. Repeat steps for remaining two preferred heights.
for 15 seconds. Release when LED display blinks. Press and hold
for 15 seconds. Release when LED display blinks. Press and hold
for 20 seconds. LED display will show
then or
for 20 seconds. LED display will show
then or
for 20 seconds. LED display will show
then or
.
until LED display shows
.
to choose a different (P) setting.
, then press
to choose a different (P) setting.
, then press
or . Standard is 15; the lower means more sensitive.
to choose a different (P) setting.
; when the desk
until LED display shows
; when the desk
.
or .
once to show
or .
twice to show
.
.
.
.