Cleaning The Plug-On Transmitter; Recommendations And Tips - Sennheiser SKP 100 G3 Instruction Manual

Cleaning the plug-on transmitter

Cleaning the plug-on transmitter
CAUTION! Liquids can damage the electronics of the plug-on
transmitter!
Liquids entering the housing of the device can cause a
short-circuit and damage the electronics.
Keep all liquids away from the plug-on transmitter.
Use a slightly damp cloth to clean the plug-on transmitter from time to
time. Do not use any solvents or cleansing agents.

Recommendations and tips

... for the plug-on transmitter
• For best results, make sure that the transmitter sensitivity is correctly
adjusted.
... for optimum reception
• Transmission range depends to a large extent on location and can vary
from about 10 m to about 150 m. There should be a "free line of sight"
between plug-on transmitter and receiving antennas.
• To avoid overloading the receiver, observe a minimum distance of 5 m
between plug-on transmitter and receiving antennas.
• The plug-on transmitter uses the microphone body as an antenna –
therefore microphones with a metal casing should be used for best
signal transmission.
... for multi-channel operation
• When operating a multi-channel system, you should only use the
channels within one frequency bank. Each of the frequency banks "1"
to "20" accommodates factory-preset frequencies which are inter-
modulation-free.
• When using several transmitters simultaneously, interference can be
avoided by maintaining a minimum distance of 20 cm between two
transmitters.
18