Advanced 1 Features - InFocus P111 User Manual

IN3144_IN3146_IN3148HD User's Manual

Advanced 1 Features

Press the Menu button to open the OSD menu. Press the ◄► buttons to move to the Settings 2
menu. Press the ▲▼ buttons to move to the Advanced 1 menu and then press
Press the ▲▼ buttons to move up and down in the Advanced 1 menu. Press the ◄► buttons to
enter and change setting values.
I
TEM
Menu Position
Translucent Menu
Low Power Mode
Fan Speed
Lamp Hour Reset
Projector ID
Network
Note:
When "Network" is enabled, VGA Out is inactive when the projector is in standby mode.
Both VGA OUT and Network control are active in standby when Low Power Mode is set to Off.
Press the ◄► buttons to enter and select different OSD location.
Press the ◄► buttons to enter and select OSD background translucent level.
Press the ◄► buttons to enter and turn Low Power Mode Off, Low Power, Network.
Press the ◄► buttons to enter and toggle between Normal and High fan speeds.
Note: We recommend selecting high speed in high temperatures, high humidity, or
high altitude (higher than 1500m/4921ft) areas.
After replacing the lamp, the lamp should be reset. See page
on Lamp Hour Reset.
Press the ◄► buttons to enter and adjust the two digit projector ID from 00 through
98.
(Enter) or ► to enter the Network menu. See page
Press
on Network.
D
ESCRIPTION
— 34 —
(Enter) or ►.
35 for more information
35 for more information