General Information - Perlick 4400QC Series Installation And Operation Instructions Manual

GENERAL INFORMATION - 4400QC SERIES POWER PAKS
Accessories
Power Cord Kit
C22296A-20--12/3 Cord, 20A, Nema Plug 5-20P,
Dedicated Circuit Models—See electrical specifications
Power Pak Racks
61790, 61790+1, 61790+2—All Models
Power Pak Wall Mounting Brackets
4408 - For Models 4404 & 4410 only
Coolant Solution-63299-1
One gallon Quick Chill Coolant solution, 33% DowFrost
HD/67% Distilled Water
Coolant Connector Kit
C23015—All Models
Leg Set - All Models
57782 . . . Set of four, 5
Pump Kits
4430QC—Pump kit, 115V, 6.1 A, 70 gph, 80 psig
Models 4410, 4410W
4431QC—Pump Kit, 115V, 5.6 A, 70 gph, 80 psig
Models 4414, 4414W
4432QC—Pump Kit, 230V, 2.8 A, 70 gph, 80 psig
Models 4414-230, 4420
INSTALLATION - 4400QC Series Power Paks
IMPORTANT SAFETY WARNINGS!
• Follow all National and Regional Codes.
• Read Installation and Operating Instructions carefully before attempting to install, operate or maintain the
product.
• Protect yourself and others by observing all safety information.
• Electrical hazards exist and can cause injuries if not serviced by properly trained personnel.
• Failure to comply with instructions could result in personal injury and/or property damage!
• Retain instructions for future reference.
• Never operate the circulating pump without coolant in the reservoir.
NOTE: Air-cooled Power Paks must be installed in areas with adequate ventilation to maintain ambient
temperatures of less than 105°F to achieve optimum performance and satisfy warranty requirements.
INSTALLING THE POWER PAK
Prior to installing a 4400QC Series Power Pak, it is imperative that the method of connecting it to the electrical
service has been determined. Ensure that the electrical service to power the Power Pak will handle the load
requirements. Perlick has a Power Cord specifically designed for a Power Pak, which has a RLA of 16 amps
or less, and a MCA of 20 amps or less. All units with RLA greater than 16 amps and a MCA of greater than
20 amps should have the Power Pak hard-wired to electrical service.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice
/ "-7 / " adjustable legs
3 1
4 2
PRODUCT DESCRIPTION
Power Paks have always been an integral part of a
Beer System. The 4400QC Series Power Pak
product line has been expanded to satisfy longer beer
runs. A Power Pak circulates coolant solution (food
grade propylene glycol with distilled water)
from the walk-in cooler to the dispensing station(s)
and back, maintaining the desired dispensing
temperature at the faucet. The 4400QC Series Power
Paks incorporate a 1/3 hp ball bearing, maintenance
free motor with a 70 gallon per hour 80 psig positive
displacement pump for optimum performance. The
4400QC series Power Pak product line employs a
direct expansion form of refrigeration increasing the
units' efficiency as well as making the units more
compact. These units also employ an electronic
temperature control with digital readout. This state of
the art control, controls the performance of the unit as
well as giving the user a visual indication of how the
unit is working as well as early indication if
something may be going wrong through the use of
internal alarms.
3 Form No. Z0507QC
Rev. 03.22.2018