Mitsubishi Electric MAC-568 User Manual page 12

Group Control
(Only available when controlling multiple units)
Group Control allows users to send a one-off command to
Select building name.
every unit within a group/building once a group/building has
been set up (for more see Section 10).
Group Control can be accessed in two ways:
1. From the selector menu: View all units >> select group/
building name >> Control all units in.
2. From the selector menu: Advanced settings >> Group
control >> select group of units to control.
Next, select whether you wish to turn all units On or Off.
If you wish to turn all units Off, simply select "Send to units"
to send this command.
If you wish to turn all units On continue to select which
Menu > Advanced Settings.
mode you wish to turn the unit on to (Selecting "Use Existing
Mode" will set the heat pump/air conditioners in the mode
they were most recently operating in).
If the mode permits, select whether you wish to turn the units
on to a set temperature. Lastly select "Send to units" to send
this command.
Please Note:
Group Control is a one-off command sent to all units, not a
"follow-me" setting where all units will adjust automatically to
replicate each other's current settings.
Turn all units on in the Office.
Keep all units at their last
mode and set temperature.
Turn all units on in the Office.
Set to Heating at 18°C.
12 12