Adding Aheat Pump - Mitsubishi Electric MAC-568 User Manual

6. ADDING A
HEAT PUMP
Adding a Unit
To add a system on the Wi-Fi Heat Pump Control service
you will need to have a compatible Mitsubishi Electric Wi-Fi
Interface connected to your Mitsubishi Electric Heat Pump
system and be connected to the Internet via a router.
You will also need the MAC Address and ID Serial Number
which can be found on page 2 of the Wi-Fi Interface
Installation Guide. If you cannot find this check the label
located on the rear side of the Wi-Fi Interface, or alternatively
please contact your heat pump installer.
1. Open Wi-Fi Control App
From the sidebar menu select 'Add New Unit.'
2. MAC (MAC Address)
MAC-568/559: The MAC Address will populate automatically
if connected correctly via the app only.
MAC-558: On the label you will see a 12 digit Hexadecimal
code, which is known as the MAC Address. Please enter this
carefully in the MAC section. This information is mandatory;
it is not possible to register a system without providing this
information.
MAC-568/558/559: If you are using Wi-Fi Heat Pump Control
via a PC you will need to input the MAC Address yourself as
per instructions above.
3. ID (Serial number)
MAC-568/559: The ID will populate automatically if
connected correctly via the app only.
MAC-558: On the label below the MAC Address you will see
a 10 digit number, which is known as the ID or Serial number.
Please enter this carefully in the ID section. This information
is mandatory; it is not possible to register a system without
providing this information.
MAC-568/558/559: If you are using Wi-Fi Heat Pump Control
via a PC you will need to input the ID or Serial Number
yourself as per instructions above.
10 10
MAC-568
4. Unit Type and Model Name
Next, select your Unit type and Model name from the drop
boxes provided. Please note, if your heat pump is not one
of the models listed in Section 14 of this manual Mitsubishi
Electric cannot guarantee Wi-Fi Heat Pump Control will
operate, neither will Mitsubishi Electric be able to provide
technical support.
5. Add Your Unit
Once you have completed entering the unit registration
information, please select the "Add" button to proceed or
"Cancel" to go back to the previous screen and cancel this
unit registration.
6. Name Your Unit
Once you have successfully added your unit to the Wi-Fi
Heat Pump Control service you can choose to rename your
unit to a more descriptive name at any stage e.g. Lounge,
Bedroom, MSZ-GE25VAD, Holiday Home etc. By default
this will show as the MAC Address number. To learn how to
rename your unit please see Section 8.
Please Note:
It is not possible to pre-register a Wi-Fi Interface before it
is installed; the Wi-Fi Interface needs to be connected and
communicating with the Wi-Fi Heat Pump Control service to
be able to complete the unit registration process.
MAC-558/559