Configuration With Console Port; Login Procedure - Patton electronics G.SHDSL NTU User Manual

Table of Contents

4 Configuration with Console Port

This chapter will deal with the specifics of configuration and operation of this product via console port with terminal

emulation program. The configuration G.SHDSL NTU is performed via a menu-driven embedded software, using a

standard ASCII terminal or a PC running a terminal emulation application connected to the rear panel CONSOLE port.

Windows includes a terminal emulation program called HyperTerminal. Connect the appropriate communication

port from the PC to this device. After the physical connection is made, you are ready to configure this product. Make

sure you have connected the supplied RS-232C serial cable (DB9F to RJ-45 Plug) to the console port on the rear panel

on this product.

Run the terminal emulation program such as Hyper Terminal with the following setting:

Emulation: VT-100 compatible

Band rate: 115200, Data bits: 8, Parity: None, Stop Bits:1 , Flow Control: None

At the start up screen, you will see:

G.SHDSL NTU User Manual V0.03

Table of Contents