ARM DSTREAM-ST Getting Started Manual page 22

3.
You do not have to perform this step if you are using a USB connection.
Use the Debug Hardware Configure IP view in DS-5 to configure Ethernet and internet protocol
settings for your DSTREAM-ST unit. You can also use the Debug Hardware Configure IP view to
assign a name for the DSTREAM-ST unit. See the DS-5 documentation for
Configure IP
4. Connect the DSTREAM-ST unit to the target hardware using the appropriate cables and connector.
5. Power up the target hardware.
ARM 100892_0100_00_en
Note
view for more details.
Copyright © 2017 ARM Limited or its affiliates. All rights reserved.
Non-Confidential
2 Setting up ARM
2.4 Connecting and powering up the DSTREAM-ST unit
Debug Hardware
DSTREAM-ST
®
2-22