Jacobsen 67971 Safety & Operation Manual page 11

K. Backlap Switch
The backlap switch allows the mowers to
! rotate in reverse for backlapping.
Forward
(mowing) the switch must be set to the
4131663
OFF (0) position.
Reverse - When backlapping, the cutting
units must be operated in the reverse
direction. Set switch to the ON (1)
position.
When backlapping, the parking brake must be set and
backlap switch (K) must be set to reverse. See Parts &
Maintenance Manual.
L. Alarm
The alarm, along with the warning lights (N, Y), sounds
to alert the operator to conditions requiring immediate
attention. See Section 3.4.
- For normal operation
M. Controller / Fuses
The controller is located under the rear hood directly
behind the operator's seat. It is equipped with LEDs to
aid in monitoring and troubleshooting the electrical
system of the mower. See Parts & Maintenance
Manual.
Two spade type fuses are located on the controller. To
replace fuses remove the access panel.
!
CAUTION
Service to the electrical system must be performed by a
trained technician. Before replacing fuses turn mower off
and remove key from ignition.
N. Hydraulic Oil Level Light
Alerts the operator of a low fluid level in hydraulic
tank. This light operates in combination with the
alarm. See Section 3.4.
NOTICE
The warning light will remain on as long as a low oil level
is detected. If the alarm sounds due to low oil level, it can
be disabled by turning switch (O) to OFF.
CONTROLS
11
3