Mounting The Base On A Wall Plate - Radio Shack ET-518 Owner's Manual

43-1018.fm Page 6 Tuesday, August 17, 1999 8:53 AM
4. Plug the adapter into a standard
AC outlet.
Caution: You must use a 120V AC/
12V DC adapter that delivers at least
200 milliamps. Its plug must correctly
fit the phone's
12V DC
plied adapter meets these require-
ments. Using an adapter that does not
meet these requirements could dam-
age the phone or the adapter.
Mounting the Base on a Wall
Plate
You need a short modular cord (such
as Cat. No. 279-390, not supplied) and
a standard wall plate (Cat. No. 279-
382, not supplied), for this mounting
method.
1. Plug one end of the short modular
cord into the
PHONE
back of the base.
6
2. Route the short cord downward
jack. The sup-
3. Route the other end of the short
4. To attach the supplied bracket to
jack on the
through the top left slot on the
base's bottom and under the clips
as shown.
cord through the hole in the
bracket's center.
the bottom of the base, insert the
tabs on the bracket into the slots
on the base, then slide the bracket
up.