Table of Contents
Advertisement
4097-00X
Power-On Self Test (POST) Sequence
Turn the printer on and check for a correct POST operation by
observing the following:
1. The power light comes on.
2. The carrier moves over the maintenance station two times and
seals the printheads.
3. The paper feed gears turn.
4. All motors stop and the power light stays on.
If your printer completes POST with no errors, go to the
Tables" on page
action.
If your printer does not complete POST, locate the symptom in the
following table and take the indicated action.
POST Symptom Table
No power light
and no motors
run
Paper feed
gears do not
turn
Carrier does not
move
Carrier slams
side frame
No busy light
2-2
Service Manual
2-3, locate the symptom and take the indicated
Go to the
"Power Service Check" on page
Go to the
"Paper Feed Service Check" on page
Go to the
"Carrier Transport Service Check" on
page
2-5.
Go to the
"Carrier Transport Service Check" on
page
2-5.
Replace the operator panel, or the system board.
"Symptom
2-11.
2-8.
Advertisement
Table of Contents
