Siemens Ay User Manual page 42

User Manual for AyAlarm
V2.1
After starting a mode or starting the AyTerminal with the PIN of the SIM card disabled and the
mode set to auto start, a screen like in Figure 5-53 is shown in following cases:
•
if the mode was started without activating the activation time option. In this case the mode
is started and also activated.
•
if the mode was started and the activation time's active option was checked and the start
time was encountered.
After starting a mode a screen like in Figure 5-54 is shown in following cases:
•
if the mode was started and the activation time's active option was checked and the start
time is not encountered.
•
if the activation time is active but the end time has been reached.
Figure 5-54 Inactive mode status screen for Car Alarm mode
The following data are shown in this screen:
•
AyTerminal Status bar
•
Mode's name
•
Active/Idle status
While a mode is started the green LED will blink.
In these screens only the deactivation code is available.
If an alarm is triggered a message will be displayed informing the user about the triggered alarm
(see Figure 5-55). In case that the alarm was triggered because the current value of a sensor
exceeded the set threshold the first displayed line contains the mode name and the second line the
pair sensor name – sensor value. The sensor name is the name of the sensor for which the value
was exceeded and the sensor value is the value of the sensor in the moment when the value was
exceeded. With the sensor value the measurement unit is also displayed (% for noise and ego-
motion sensors and °C for temperature sensor). If the alarm was triggered but no sensor was
involved then the second displayed line is replaced by the text "Alarm!". This is the case of Alarm
Clock where the alarm is triggered by a timer and of Voice Call where the alarm is triggered if the
defined phone number was dialled. The screen is updated whenever something changes on
AyTerminal (e.g call phone established, call phone ended). After alarm duration the mode returns
in Active state which is indicated on display.
Be aware that no
notifier is
activated.
Figure 5-52 No notifier activated message box
Car alarm
Active
Figure 5-53 Active mode status screen for Car Alarm mode
Car alarm
Idle
Be aware
that no
notifier is
Car alarm
Active
Car alarm
Idle
AyTerminal
AyAlarm application