Table of Contents
Advertisement
announces the day and time of the call at the
end of each message.
To play all messages after playing the new
messages, press
PLAY/STOP
To skip to the next message, press
while the message is playing. Hold down
; ; ; ;
/
to fast forward through the
SKIP
messages. Release
SKIP
normal playback.
To replay the current message from the
: : : :
beginning, press
/
REPEAT
to review the current message. The
REPEAT
system skips back every other second of
playback and plays the previous second,
until the beginning of the message. Release
: : : :
/
to resume normal playback.
REPEAT
: : : :
If you press
/
within about 2
REPEAT
seconds (4 seconds during remote
operation) after a message begins playing,
the system replays the previous message. If
the current message is the first new
message, the system plays back from the
beginning of the current message (it does
not go back into the old message group).
ADJUSTING THE
ANSWERING SYSTEM'S
VOLUME
To adjust the speaker's volume, repeatedly
8 8 8 8
9 9 9 9
press
or
VOLUME
& & & &
volume setting from
(lowest) to
appears in the message counter window.
DELETING MESSAGES
To delete the current message while it is
playing, press
. The answering
DELETE
system beeps.
To delete all messages, while messages are
not playing, hold down
DELETE
until the system beeps and announces
18
again.
; ; ; ;
/
SKIP
; ; ; ;
/
to resume
: : : :
. Hold down
/
on the base. The
/ / / /
(highest)
on the base
Answering System Operation
"Messages have been deleted."
the message counter window.
Note: You cannot delete new (unplayed)
messages. If you try to delete all messages
while you still have new messages, the
system beeps and announces "Please play
back all messages."
REMOTE OPERATION
While you are away from your home or
office, you can use a touch-tone phone, or a
pulse (rotary) phone with a pocket tone dialer
(available through your local RadioShack
store), to enter your security code and do
any of the following:
• Set the system to answer or not answer
calls.
• Listen to your messages.
• Record a new outgoing message.
• Record a memo.
• Erase messages.
You cannot remotely operate the system
using its handset or another telephone on
the same line as the system.
Setting the Security Code
The system's two-digit remote operation
security code prevents unauthorized remote
access to your messages. The code is
preset to 80.
Follow these steps to change the code to any
number from 00 to 99.
1. Press
three times. The system
MENU
announces "Security code," followed by
the currently set code. The display also
shows the code.
2. Press
.
SET
& & & &
appears in
Advertisement
Table of Contents
