Table of Contents
Advertisement
SETTING THE DIALING
MODE
Your phone is set for tone dialing. If you have
pulse service, you must change the dialing
mode. If you are not sure which type of
service you have, do this test.
Lift the handset, press
TALK
dial tone. Press any number other than
your phone system requires that you dial an
access code (
, for example) before you dial
9
an outside number, do not press the access
code either.
If the dial tone stops, you have touch-tone
service. If the dial tone continues, you have
pulse service.
To set the dial mode, press
the phone if necessary, then hold down
until the phone beeps. Then press
FLASH
to set pulse mode or /
TONE
mode. The phone beeps.
Notes:
• The phone exits setting mode if a call or
page is received, or if you press
• If the battery pack power gets too low,
the dial mode might reset to tone. If you
are on a pulse line and cannot make a
call, try setting the dialing mode to
pulse.
SETTING THE HANDSET
RINGER'S TONE AND
VOLUME
You can select one of four different ringer
tone/volume settings on the handset. At any
time except during a call, repeatedly press
to select the desired ringer setting.
VOLUME
Each time you press the button, the phone
rings at the selected setting.
10
TURNING THE BASE'S
RINGER ON/OFF
You can set the base's ringer to high or low,
or turn it off.
Press
announces "Ringer volume" followed by its
, and listen for a
current setting. The display also shows the
. If
current setting.
0
1. Press
to hang up
TALK
#
to set tone
2. Press
.
TALK
3. Press
4. Press
Even when you turn off the base's ringer, you
can still make or receive calls using this
phone. Telephones on the same line (and
the handset if it is away from the base) still
ring when there is an incoming call.
Installation
four times. The phone
MENU
to enter the setting mode.
SET
Note: The system exits the setting mode
when you:
• wait more than 20 seconds between
key presses
• receive an incoming call
• press
PLAY/STOP
• press
on the handset
TALK
Start again at Step 1.
; ; ; ;
: : : :
or
SKIP/
/REPEAT
the setting. The system announces the
setting and the display shows
E< E< E< E<
.
to store the setting.
SET
to exit the menu
PLAY/STOP
setting mode.
to change
>_ >_ >_ >_
Be Be Be Be
,
, or
Advertisement
Table of Contents
