Omron VARISPEED E7 User Manual page 66

Key Name
FWD/REV Key
Shift/RESET Key
Increment Key
Decrement Key
DATA/ENTER Key
RUN Key
STOP Key
Note: Except in diagrams, Keys are referred to the Key names listed in the above table.
There are indicators on the upper left of the RUN and STOP keys on the Digital Operator. These indicators
will light and flash to indicate operating status.
The RUN key indicator will flash and the STOP key indicator will light during initial excitation or DC brake.
The relationship between the indicators on the RUN and STOP keys and the Inverter status is shown in
Fig 3.33.
Inverter output frequency
Frequency setting
: Light up
Table 3.1 Key Functions
Selects the rotation direction of the motor when the Inverter is being
operated from the Digital Operator.
Sets the active digit when programming user parameters.
Also acts as the Reset key when a fault has occurred.
Selects menu items, sets user parameter numbers, and increments set
values.
Used to move to the next item or data.
Selects menu items, sets user parameter numbers, and decrements set
values.
Used to move to the previous item or data.
Pressed to enter menu items, user parameters, and set values.
Also used to switch from one screen to another.
Starts the Inverter operation when the Inverter is being controlled by
the Digital Operator.
Stops Inverter operation.
This key can be enabled or disabled when operating from the control
circuit terminal by setting user parameter o2-02.
: Blinking
: Not light up
Fig 3.2 RUN and STOP Indicators
Function
3
3
3-