Lubrication - Husqvarna Z560 series Operator's Manual

LUBRICATION

Lubrication Schedule
12/12 Every year
1/52 Every Week
1/365 Every day
General
Remove the ignition key to prevent accidental
movements during lubrication.
When lubricating with an oil can, it must be
filled with engine oil. When lubricating with
grease, unless otherwise stated, use high grade
molybdenum disulphide grease.
For daily use, the machine must be lubricated
twice weekly.
Wipe away excess grease after lubrication It
is important to avoid getting lubricant on the
belts or the drive surfaces on the belt pulleys.
If this happens, clean them with spirits. If the
belt continues to slip after cleaning, it must be
replaced. Gasoline or other petroleum products
must not be used to clean belts.
*
Initial hydraulic oil and filter change at
100 hrs, every 400 hrs thereafter.
p Change engine oil every 50 hours.
Lubricate with grease gun
Filter change
Oil change
Level check
WARNING! Escaping hydraulic oil
under pressure can have sufficient force to
penetrate the skin, causing serious injury. If
injured by escaping fluid, see a doctor at once.
Serious infection or reaction can develop if
proper medical treatment is not administered
immediately.
IMPORTANT INFORMATION Use minimal
lubrication and remove excess lubricant so that
is does not come into contact with belts or belt
pulley drive surfaces.
27