Graco PR70 Operation & Maintenance Manual page 36

Setup
System Data Screen
MA
Key:
MA Enter/Exit Screen
MB Current Machine Cycles Counter
MC Total Machine Cycles Counter
MD Advanced Display Module Software
ME Fluid Control Module #1 Software
MF Fluid Control Module #2 Software
MG Temperature Control Module -
F . 21
IG
Software Version
Software version will read "0.00.000" if component can-
not be seen by the ADM. This is the result of the compo-
nent not being installed or a communication error.
Machine Cycles
A machine cycle is one full extension and retraction of
the machine piston. The Current Machine Cycles
Counter is resettable and the Total Machine Cycles
Counter is the number of cycles since the ADM was
installed. Reprogramming the ADM will not reset the
Total Machine Cycles counter.
36
Version
Version
Version
Zone #1 Software Version
ML
MM MM
MH Temperature Control Module -
Zone #2 Software Version
MJ Temperature Control Module -
Zone #3 Software Version
MK Temperature Control Module -
Zone #4 Software Version
ML Active Screen Name
MM Adjacent Screen Names
MN Resettable material weight counter
MP Non-resettable material weight
counter
Reset Current Machine Cycles Counter
1. Press the Enter/Exit Screen button (MA) to enter the
screen. The Current Machine Cycles count will be
highlighted.
2. Press the Enter button (
Machine Cycles counter.
3. Press the Enter/Exit Screen button (MA) to exit the
screen.
MB
MC
MN
MP
MD
ME
MF
MG
MH
MJ
MK
) to reset the Current
312759W