Battery Power - Kingfisher KI 9600A-Ge Operation & Maintenance Manual

BATTERY POWER

These instruments are powered by two 1.5 V dry alkaline 'AAA' size
batteries. Alternatively, use re-chargeable NiCad or NiMH batteries:
Model
KI 9600 Optical Power Meter
KI 9800 Optical Light Source
When the batteries are low, the low battery indicator is shown on the
display. At this stage, there is approximately enough energy for
another 20 hours of use.
To save energy, the instrument automatically turns off after 10 minutes
without operation.
KI 9000 UM-10
Battery run time in hours
300
Laser/LED source: 40/35 hours in
Autotest, typical
To change the batteries, open the cover of the battery compartment at
the side of the instrument, remove the batteries and insert new ones.
When an instrument is put away for storage, it is good practice to
remove batteries to prevent the possibility of battery acid leakage
damaging the equipment.
CAUTION!
Do not use lithium batteries or other batteries with a nominal voltage
greater than 1.8 V. The instrument may be damaged.
Protect our environment! Batteries purchased from Kingfisher agents
can be returned to them for appropriate disposal.
10