D-Link DAP-3520 User Manual page 36

DAP-350 User's Manual
User Name:
Password:
Retype Password:
Service Name:
IP Address:
Get DNS from:
Primary DNS Address:
Secondary DNS Address:
Connect Mode Select:
MAC Source:
MAC Address:
D-Link AirPremier N Dual Band Exterior PoE Access Point
Enter your PPPoE user name.
Enter your PPPoE password.
Retype your PPPoE password.
Enter the ISP Service Name (optional).
Enter the IP address (Static PPPoE only).
Toggle between Receive DNS from ISP and Enter DNS Manually
depending on how you will obtain your Domain Name Server
information.
Enter the primary DNS (Domain Name Server) server IP address
assigned by your ISP.
Enter the secondary DNS (Domain Name Server) server IP address
assigned by your ISP, if applicable.
Select either Always On, Manual, or Connect On Demand.
You may need to change the Maximum Transmission Unit for optimal
MTU:
performance with your specific ISP. The default MTU is 1492.
Enable: The default MAC address is set to the WAN's physical interface MAC
address on the DAP-3520. You can tick this Clone MAC Address
Enable check box to copy the MAC address of the Ethernet Card
installed by your ISP and replace the WAN MAC address with the
MAC address of the DAP-3520. It is not recommended that you
change the default MAC address unless required by your ISP.
Use the drop-down menu to select Auto or Manual.
Manually enter an appropriate MAC address or click the Scan button
to search for a specific MAC address
Using the Configuration Menu
36