Setup; Required Equipment; Equipment Assembly; 173X/174X Calibration Cable Assembly - Fluke 1746 Calibration Manual

1742/1746/1738
Calibration Manual

Setup

Before you start the verification procedures or make calibration adjustments, refer to this section for the
equipment, system, and setup requirements.

Required Equipment

See Table 4 for a list of requirements for the verification tests and calibration adjustment of the Logger.
Calibrator
Digital Multimeter (DMM)
Cable Assembly
173x/174x AUX Input
Calibration Cable
173x/174x Calibration Cables –
Voltage-to-Current Input Cable
Assembly
173x/174x Verification Box
USB cable
Coil
Coil
Banana-to-Pin Adapter
[1] The 173x/174x calibration cables and verification box are not available from Fluke. See Equipment Assembly for
information on how to make these items.

Equipment Assembly

The 173x/174x calibration cables and verification box are not available from Fluke. If you plan to calibrate
your Product rather than send it to a Fluke Service Center, use the assembly instructions that follow.

173x/174x Calibration Cable Assembly

See Table 5 for instructions on how to make the calibration cables.
Cable must be marked with "max. 30 V to earth." Remove any voltage-, category-, or
current-ratings on safety plugs.
14
Equipment
5520A/5522A with
8508A Reference
DMM
8508Aor 8846A
3PHVL-1730
NA
[1]
NA
[1]
[1]
NA
type A-to-mini B
5500A/COIL
Optional: 52120A
with Coils
NA
Pomona
Electronics 4690
Table 4. Required Equipment
Model Notes
Use 5700A/5730A
Calibrator if 8508A is
not available.
Voltage verification/
calibration and AUX
Adapter verification
Voltage Test Lead
3-Phase+N
1732/1734/1736/1738 only
1732/1734/3540 FC:
Qty. 3 required
1736/1738:
Qty. 4 required
for Flexi verification
5 turns
for AUX Adapter
verification
W Caution
Used on:
Verification Calibration
Tests Adjustment
X X
X X
X X
X X
X X
X
optional
X X
X
X
X