Table of Contents
Advertisement
Engine Welders/K1587-1 Cobramatic Connection Diagram
Do not operate with panels open.
Disconnect NEGATIVE (-) Battery lead before servicing.
Do not touch electrically live parts.
Keep guards in place
Keep away from moving parts.
Only qualified personnel should install, use or service this equipment
Any increase of the high idle engine RPM by changing the governor setting or overriding the throttle linkage will cause an
increase in the ac wire feeder voltage, which can damage the control circuit. The engine governor setting is pre-set at the
factory – DO NOT ADJUST above RPM specifications listed in the engine welder operating manual.
A.
WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE
AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
B.
SET THE WIRE FEEDER VOLTMETER TO THE "+" POSITION. THE POSA-START FEATURE WILL NOT
OPERATE UNLESS THIS SWITCH IS SET TO MATCH THE POLARITY OF THE ELECTRODE CABLE.
C. POSIYION THE MODE SWITCH TO "CV-WIRE".
English
WARNING
WARNING
TO COBRAMATIC WIRE FEED CABINET
INPUT CABLE PLUG
ELECTRODE CABLE
TO WIRE FEED
CABINET
WARNING
21
TO WORK
S24787-10
English
Advertisement
Table of Contents
