Lincoln Electric RANGER 305D CE Operator's Manual page 23

Engine Welders/K930 Tig Module Connection Diagram

Do not operate with panels open.

Disconnect NEGATIVE (-) Battery lead before servicing.

Do not touch electrically live parts.

Keep guards in place

Keep away from moving parts.

Only qualified personnel should install, use or service this equipment
REGULATOR
FLOWMETER
ARGON GAS
CYLINDER
K936-1
CONTROL CABLE
Any increase of the high idle engine RPM by changing the governor setting or overriding the throttle linkage will cause an
increase in the ac wire feeder voltage, which can damage the control circuit. The engine governor setting is pre-set at the
factory – DO NOT ADJUST above RPM specifications listed in the engine welder operating manual.
A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF
IMMEDIATE AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY.
C. PLACE THE MODE SWITCH IN THE "TIG" POSITION.
D. PLACE OUTPUT CONTROL SWITCH TO "REMOTE CONTROL" POSITION.
E. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
English
WARNING
WARNING
TO GAS
INPUT
FITTING
ELECTRODE
WARNING
20
K870 FOOT AMPTROL
-OR-
K963-1 HAND AMPTROL
-OR-
K814 ARC START SWITCH
TO WORK
S24787-9
English