Wiring Schematic - Delta Membranes AlertMaxx2 Installation & Operating Manual

AlertMaxx2
8.0

Wiring schematic

The AlertMaxx2 is different from a standard high level alarm as the pump/s require to be fed through the unit.
This way of connectivity allows the AlertMaxx2 to collect various different parameters directly from the pumps
and when connected via Wi-Fi, this data can be used to intelligently plan maintenance and service schedules to
the specific pump station it is connected to (see page 15).
6
Separate 16 Amp RCBO's
13 Amp Non-switched
fused spur
Finger Float Switch
Supplied with a 10m cable
- The pump is supplied with a 10m cable.
- When only using the standard 10m
cable attached to the pump, the cable
duct should be no longer than 6m.
- If the cable duct requires to be longer
than 6m, please follow the cable
extension guide to select an appropriate
cable core diameter.
The electrical installation must comply with the requirements of
Electrical Installations' incorporating amendment 3:2015
AlertMaxx2 High Level Alarm
(DMS-269-2)
For internal wiring of the high
level alarm, please refer to the
AlertMaxx2 instruction manual.
BS 7671:2008 'Requirements for
Figure 1. AlertMaxx2 wiring schematic