Hi-Powermaxx Connection - Delta Membranes AlertMaxx2 Installation & Operating Manual

AlertMaxx2

21.0 Hi-PowerMaxx Connection

The AlertMaxx2 can be connected to a PowerMaxx, PowerMaxx+ or Hi-PowerMaxx to provide additional battery
backup and if connected via W-Fi, battery backup capacity and condition is fed directly to the PPS OpCentre.
The PowerMaxx, PowerMaxx+ and Hi-PowerMaxx are supplied with 3m of 4 core MaxxConnect family cable.
The AlertMaxx2 can only be connected to PowerMaxx, PowerMaxx+ and Hi-PowerMaxx which is
running the software version 3.0 or higher. This can be identified by the software identification sticker
on the back of the battery backup units.
Please refer to the battery backup instruction manual for final connections.
Figure 7. AlertMaxx2 Hi-PowerMaxx connection terminal
PLEASE NOTE
For wiring the pumps, please refer to the Hi-PowerMaxx manual.
The AlertMaxx2 must be installed in series to the Hi-PowerMaxx - this means the AlertMaxx2 must
be installed in between the Hi-PowerMaxx & the pump/s.
15